Path: utzoo!utgpu!jarvis.csri.toronto.edu!mailrus!csd4.milw.wisc.edu!lll-winken!uunet!mcvax!hp4nl!botter!klipper.cs.vu.nl!rcwlobe
From: rcwlobe@klipper.cs.vu.nl (Reg Lobee)
Newsgroups: comp.sys.cbm
Subject: Re: (none)
Summary: simple
Keywords: User Port, Hardware Reset
Message-ID: <2229@botter.cs.vu.nl>
Date: 1 May 89 14:42:39 GMT
References: <6957@bsu-cs.bsu.edu>
Sender: news@cs.vu.nl
Lines: 14

In article <6957@bsu-cs.bsu.edu>, wendi@bsu-cs.bsu.edu (Walter H. Dick) writes:
> Can anyone tell me how I can ground pin 3 (User Port), so the computer
> will do a reset?  Thanks in advance!

     pin3-------- switch --------pin1
     reset                        gnd

The switch must only be pressed for a short while.
This works fine without any additional parts.

|^^\   | Reg Lobee        |=====================================|
|__/   | rcwlobe@cs.vu.nl | To establish voice contact, don't   |
|\     | V.U. University  | shout at the keyboard. Use a phone! |
| \ eg | The Netherlands  |=====================================|